Introduction of each production line

2/35KV medium and high voltage cable production equipment
The equipment is fully attached and belongs to a complete production area. It is used to produce medium and high voltage cables made of aluminum or copper.
Parallel line production equipment
The device is used to pack more than two finished cables together, run them on a circular cable reel, and send them to the customer after the outer packaging.
Overhead cable stranding equipment
The equipment is used to twisted together the insulated wire core of multiple overhead cables or a bare conductor, formed, packaged and transported to the customer.
Low voltage cable production line
It is used to add a jacket or insulation layer outside the conductor; Add insulation layer after the shield armor is finished; There is a laser device in the device for laser lettering on the insulation layer.
MV LV Cable extruder equipment
The insulation or jacket particles are drawn into the extruder equipment through a white hose powered, and the raw material is melted by high temperature, and finally uniformly adhered to the cable conductor.
Extruder extracts insulation particles
The insulating or jacket raw material is placed in a non-polluting compartment for extraction by the extruder equipment.
Cable bare conductor production equipment
This equipment is used to produce copper or aluminum conductors. Install the copper wire or aluminum wire wheel on the wire stranding equipment, install a certain number of monofilm wheels according to the demand, start the conductor production equipment for stranding, and finally become the cable conductor.
Wire drawing production equipment
These wire drawing production equipment produce aluminum or copper wire for sale or as a raw material for cable conductors.